Scantool Ready-or-Not Bedienungsanleitung PDF herunterladen (Seite 12)

4 Program the Ready-or-Not

4.1 Connect the test tool to the PC

To connect the Ready-or-Not test tool for programming, follow these

steps:

1. Plug the DB9 male end of the serial cable into the DB9 female

connector of the test tool, as shown:

2. Plug the other end of the serial cable into the COM port of your

PC. Note that the COM port is a , male connector.

The Ready-or-Not is designed to be powered from the COM port in

programming mode, and does not require an additional power

supply.

9-pin

Hint: Some third-party USB to Serial converters may not provide

enough voltage for the proper operation of the Ready-or-Not.

If your PC does not have a built-in COM port, refer to the "Accesso-

ries" chapter of this User Guide for information on ordering an

approved USB to Serial converter.

Ready-or-Not

Ready-or-NotReady-or-NotReady-or-Not

CAT

EVAP

SEC. AIR

O HTR

EGR

READY NOT READY

DELLDELL

COM Port

Program the test tool

12 Ready-or-Not User Guide

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Scantool Ready-or-Not Bedienungsanleitung Seite 12