Scantool S OBDLink Bedienungsanleitung PDF herunterladen

1. Install OBDwiz software 2. Locate the diagnostic connector.

Insert the software CD in your CD-ROM drive.

The scan tool selection menu will automatically

appear:

5. Launch OBDwiz software

To launch the software, click on Start

Programs . Click the Auto

Detect button, then click the Connect button.

6. Technical support

Should you run into problems, technical support

is just a click away:

3. Connect scan tool to the DLC

Turn the vehicle’s ignition to the Key On, Engine

Off position. Follow connection diagram (directly

Click on the icon labeled OBDLink S, to display

below) to connect OBDLink S to the diagnostic

the software selection menu:

connector (steps & ).

4. Connect scan tool to the PC

Connect OBDLink S to your PC's serial port using

the gray serial cable (steps & ).

Click on OBDwiz, and follow the prompts to

install the software.

Note that some laptops do not have a built-in

serial port. Inexpensive USB to Serial converters

are available from the ScanTool.net website, or

your local computer store.

If the menu does not appear, click StartgRun,

type D:\setup.exe (where ‘D’ is the drive letter of

your CD-ROM drive), and click OK.

Watch the lights on the scan tool as you are

performing step Both sets of Tx/Rx lights will

be lit up in sequence from left to right.

The 16-pin D-shaped diagnostic link connector

(DLC) should be located in the passenger or

gOBDwizgOBDwiz

driver's compartment in the area bounded by the

driver's end of the instrument panel to 300 mm

(~1 ft) beyond the vehicle centerline, attached to

the instrument panel and easy to access from the

driver's seat. The preferred location is between

the steering column and the vehicle centerline.

— Knowledgebase - contains answers to

the most commonly asked questions,

general information about OBD-II, and

troubleshooting information.

— Forum - allows you to share information

and get support from other OBDLink S

users.

These resources can be accessed from our

website:

A B

C D

www.ScanTool.net.

S Quick Start

OBDOBDOBD

vehicle

OBD-II cable

C D

serial cable

computer

1 2

Inhaltsverzeichnis

Seite 1 - OBDOBDOBD

1. Install OBDwiz software 2. Locate the diagnostic connector.Insert the software CD in your CD-ROM drive. The scan tool selection menu wi

Seite 2 - Thank you for your purchase!

Thank you for your purchase!Please consider leaving feedback on:

Kommentare zu diesen Handbüchern

Keine Kommentare

Scantool S OBDLink Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Software Scantool S OBDLink herunter. ScanTool S OBDLink User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Scantool S OBDLink