Scantool OBDLink Bedienungsanleitung PDF herunterladen

1. Install drivers 2. Locate the diagnostic connector 5. Install OBDwiz software

Insert the software CD in your CD-ROM drive. From the OBDLink menu click on OBDwiz, and

The scan tool selection menu will automatically follow the prompts to install the software:

appear. Click on the icon labeled OBDLink:

6. Launch OBDwiz software

To launch the software, click on Start

Programs . Click the Auto

Detect button, then click the Connect button.

3. Connect scan tool to the DLC

Technical support

Turn the vehicle’s ignition to the Key On, Engine

Should you run into problems, technical support

The OBDLink menu will appear. Click on the

Off position. Follow connection diagram (bottom

is just a click away:

driver link for your operating system and install

of page) to connect OBDLink to the diagnostic

the drivers:

connector using the OBD-II cable (steps & ).

4. Connect scan tool to the PC

Connect OBDLink to your PC's USB port using

the USB cable (steps & ).

If the menu does not appear, click StartgRun,

type D:\setup.exe (where ‘D’ is the drive letter of

your CD-ROM drive), and click OK.

With step completed, watch the LEDs as you

are performing step . The "STATUS" LED will

glow red (or alternate between red and amber if

the Bluetooth option is installed) and the Tx/Rx

LEDs will cycle on and off in sequence from left to

right .

The 16-pin D-shaped diagnostic link connector

(DLC) should be located in the passenger or

driver's compartment in the area bounded by the

driver's end of the instrument panel to 300 mm

(~1 ft) beyond the vehicle centerline, attached to

the instrument panel and easy to access from the

driver's seat. The preferred location is between

gOBDwizgOBDwiz

the steering column and the vehicle centerline.

— Knowledgebase - contains answers to

the most commonly asked questions,

general information about OBD-II, and

troubleshooting information.

— Forum - allows you to share information

and get support from other ElmScan 5

users.

These resources can be accessed from our

website:

A B

C D

www.ScanTool.net

Quick Start

vehicle

OBD-II cable

USB cable

computer

scan tool

C D

OBD

POWER

Tx Rx Tx Rx

STATUS

Tx Rx Tx Rx

OBDOBDOBD

1 2

Inhaltsverzeichnis

Seite 1 - Quick Start

1. Install drivers 2. Locate the diagnostic connector 5. Install OBDwiz software Insert the software CD in your CD-ROM drive. From the OBDLi

Seite 2 - Thank you for your purchase!

Thank you for your purchase!Please consider leaving feedback on:

Kommentare zu diesen Handbüchern

Keine Kommentare

Scantool OBDLink Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Scantool OBDLink herunter. ScanTool OBDLink User Manual [en] [de] Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Scantool OBDLink