Scantool STN11xx Bedienungsanleitung

STN11xx PowerSave Functionality © 2010 ScanTool.net, LLC www.ScanTool.net STN11XXPSB

STN11xx PowerSave Table 1 – PowerSave Configuration Summary Detail Configuration Summary Line Sec. Description CTRL MODE: <NATIVE/ELM327>

STN11xx PowerSave <level> voltage threshold in volts ([d]d.ddV) or raw ADC steps (0xhhh) <time> number of consecutive seconds the volt

STN11xx PowerSave SLU sleep, wakeup UART sleep/wakeup triggers on/off. Each of the two parameters can be independently configured as “on” or “off”

STN11xx PowerSave SLXST ms SLXWT ms Specifies how long the SLEEP input must be held in the active (“sleep”) state to put the device to sleep. The m

STN11xx PowerSave Table of Contents 1.0 PowerSave Functionality ...

STN11xx PowerSave 1.0 PowerSave Functionality STN11xx features a sophisticated power manage-ment system (PowerSave™) that can be used to put the dev

STN11xx PowerSave randomly toggle the UART communication lines and can unintentionally wake up the device as they are shutting down or entering th

STN11xx PowerSave 1.3.1 UART Rx Pulse Wakeup STN11xx can be configured to wake up on an active pulse detected on the UART Rx input. The host can ge

STN11xx PowerSave to Digital Converter (ADC for short). The voltage represented by a single bit is called an “ADC step”, and is measured in volts

STN11xx PowerSave The STN1100 turns off the “STATUS” LED during sleep. Note 1: In sleep mode about 15 mA of current will be drawn from the USB sock

STN11xx PowerSave 1.7 Trigger Summary Sleep Triggers Trigger Default state ATLP User initiated. This trigger is available only in ELM327 Low Pow

STN11xx PowerSave 2.0 PowerSave ST Commands The following sections describe the PowerSave ST commands. For brevity, the “ST” prefix is dropped in th